Using PlayStation 1 Densha de Go controller on emulators
Items needed Arduino Leonardo (or equivalent). Note that it has to have at least one 3.3V power output. A standard PlayStation 1 controller A Densha de Go controller 6 male-to-female jumper cables Procedure Initial Cabling Using the jumper cable, connect the typical PlayStation 1 controller with the Arduino Leonardo. PlayStation 1 controller pin numbers --------------------- \ 1 2 3 4 5 6 7 8 9 / ------------------- Connection to Arduino Leonardo * PlayStation 1 controller pin 1 (DATA) --> Arduino Leonardo digital port 12 * PlayStation 1 controller pin 2 (CMD) --> Arduino Leonardo digital port 11 * PlayStation 1 controller pin 4 (GND) --> Arduino Leonardo port GND * PlayStation 1 controller pin 5 (VCC) --> Arduino Leonardo port 3.3V * PlayStation 1 controller pin 6 (ATT) --> Arduino Leonardo digital port 5 * PlayStation 1 controller pin 7 (CLK) --> Arduino Leonardo digital port 4 Set up Arduino IDE Install the IDE is available at https://www.arduino.
thanx for info, but i prefer to use this tool http://www.macvide.com/Macvide_FlashVideo_Converter/, it converts flash to video in great quality!)
ReplyDelete